ClicOn No Holes Centre Mount for Ford Ranger 16-20

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 655184
 

This Dash Mount allows you to mount your mobile device on your Ford Ranger 16-20 without drilling holes on your dashboard and keeps your interior damage-free.

Ford Ranger 16-20 ClicOn Centre Mount has pre-drilled AMPS pattern holes.

Fits: 

Ford Ranger 16-20

Please Note: Not for Wildtrak Models.

Not the product you are looking for? Go to www.strike.com.au/products/dashmounts to start again.




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders.

Attention! Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be
installed. Press the thin end of the enclosed gap opener into the seam/gap between the center console panel and the padded console edge, to widen the gap. Peel off the cover of adhesive tape on the ClicOn.

2. Press the angled edge on the right side of the ClicOn into the gap in front of the gap opener.

3. Place your thumbs on the top of the ClicOn and your index fingers on the inside of the ClicOn to make sure the angled edge clears off the console sidewall. Press down on top of the ClicOn with your thumbs so the ClicOn flexes downwards, and then hook the angled edge around the console edge by the carpet. Pull out the gap opener.

4. The ClicOn is in place.

Attention! Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be
installed. Press the thin end of the enclosed gap opener into the seam/gap between the center console panel and the padded console edge, to widen the gap. Peel off the cover of adhesive tape on the ClicOn.

2. Press the angled edge on the right side of the ClicOn into the gap in front of the gap opener.

3. Place your thumbs on the top of the ClicOn and your index fingers on the inside of the ClicOn to make sure the angled edge clears off the console sidewall. Press down on top of the ClicOn with your thumbs so the ClicOn flexes downwards, and then hook the angled edge around the console edge by the carpet. Pull out the gap opener.

4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount