This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles
Please read all of the instructions and look at the pictures before attaching the ClicOn.
1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Remove the adhesive tape covers on the ClicOn. Insert the lower angled edge of the ClicOn into the gap on the lower inside of the air vent. Make sure the right side of the ClicOn aligns with the gap next to the padded part of the center console, according to the picture.
2. Slide the ClicOn rightward until it is centered on top of the padded side of the center console. Move the ProClip forward/upward, at the same time flex the upper angled edge of the ProClip downward.
3. Insert the angled upper edge of the ClicOn into the gap on the upper inside of the air vent. Make sure the adhesive tape fastens properly.
4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount