ClicOn No Holes Dash Mount for Jeep Cherokee 14-20

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 655026
 

ClicOn Dash Mount for Jeep Cherokee 14-20

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Jeep Cherokee 14-20




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Please read the instructions and look at the pictures before installing the ClicOn.

 

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel of the adhesive tape cover on the ClicOn. Place the ClicOn over the area where it will be attached for proper alignment. Place your finger at the bottom edge to mark the placement.

 

2. Where your finger is marking the placement, press the lower angled edge of the ClicOn into the seam between the padded upper dash and the lower solid part of the dash. The lower edge of the ClicOn will hook behind the lower dash panel as you rotate the ClicOn upward.

 

3. Rotate the ClicOn upward so the angled edge on the lower part hooks behind the lower dashboard panel. Then pull the upper part of the ClicOn upward to hook the angled upper edge of the ClicOn over the air vent edge.

 

4. The seam between the vent frame and inside of the vent is a tight seam. To make the upper angled edge of the ClicOn go all the way into the seam between the air vent and the surrounding panel frame, pull the ClicOn towards you and press down at the same time. It might need to be wiggled a little. Listen for the click as the ClicOn goes into place.

Please read the instructions and look at the pictures before installing the ClicOn.

 

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel of the adhesive tape cover on the ClicOn. Place the ClicOn over the area where it will be attached for proper alignment. Place your finger at the bottom edge to mark the placement.

 

2. Where your finger is marking the placement, press the lower angled edge of the ClicOn into the seam between the padded upper dash and the lower solid part of the dash. The lower edge of the ClicOn will hook behind the lower dash panel as you rotate the ClicOn upward.

 

3. Rotate the ClicOn upward so the angled edge on the lower part hooks behind the lower dashboard panel. Then pull the upper part of the ClicOn upward to hook the angled upper edge of the ClicOn over the air vent edge.

 

4. The seam between the vent frame and inside of the vent is a tight seam. To make the upper angled edge of the ClicOn go all the way into the seam between the air vent and the surrounding panel frame, pull the ClicOn towards you and press down at the same time. It might need to be wiggled a little. Listen for the click as the ClicOn goes into place.

Contains 1 x ClicOn No Holes Dash Mount for Jeep Cherokee 14-20