ClicOn No Holes Dash Mount for Skoda Octavia RS 13-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 654885
 

ClicOn Centre Mount for Skoda Octavia RS 13-14

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided. ONLY for models with factory navigation. Dev

Fits:

Skoda Octavia III 13-17




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Please read the instructions and look at the pictures before attaching the ClicOn. This ClicOn can be placed on desired place on the width of the air vents.

 

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn. Press the thin end of the enclosed gap opener into the gap surrounding the center console control panel, to widen the gap.

 

2. Press the lower angled edge of the ClicOn into the gap next to the gap opener.

 

3. Press the top part of the ClicOn forward and at the same time flex it downward so the top part of the ClicOn can go in at the top edge of the air vent. Release pressure of the ClicOn so it flexes back and the adhesive tape attaches. Remove the gap opener.

 

4. The ClicOn is in place.

Please read the instructions and look at the pictures before attaching the ClicOn. This ClicOn can be placed on desired place on the width of the air vents.

 

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn. Press the thin end of the enclosed gap opener into the gap surrounding the center console control panel, to widen the gap.

 

2. Press the lower angled edge of the ClicOn into the gap next to the gap opener.

 

3. Press the top part of the ClicOn forward and at the same time flex it downward so the top part of the ClicOn can go in at the top edge of the air vent. Release pressure of the ClicOn so it flexes back and the adhesive tape attaches. Remove the gap opener.

 

4. The ClicOn is in place.

Contains 1 x vehicle specific dash mount