ClicOn No Holes Dash Mount for Hyundai Elantra GT 12-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 654836
 

ClicOn Centre Mount-Low for Hyundai Elantra GT 12-14

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided. ONLY for models with factory navigation. Dev

Fits:

Hyundai Elantra GT 12-17




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Press the thin end of the enclosed gap opener into the gap between the console sidewall and the panel surrounding the power outlet, to widen the gap. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn. Hook the angled edge on the right side of the ClicOn around the console edge.  
 
2. Slide the ClicOn upward until it stops.  
 
3. Place your index fingers behind the upper and lower edge on the right side of the ClicOn and pull towards you, and then push/hook the left angled edge around the console edge. Pull out the gap opener.  
 
4. The ClicOn is in place.

Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Press the thin end of the enclosed gap opener into the gap between the console sidewall and the panel surrounding the power outlet, to widen the gap. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn. Hook the angled edge on the right side of the ClicOn around the console edge.  
 
2. Slide the ClicOn upward until it stops.  
 
3. Place your index fingers behind the upper and lower edge on the right side of the ClicOn and pull towards you, and then push/hook the left angled edge around the console edge. Pull out the gap opener.  
 
4. The ClicOn is in place.

Contains 1 x vehicle specific dash mount