ClicOn No Holes Dash Mount for Smart ForTwo 11-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 654827
 

ClicOn Angled Mount with Navigation for Smart ForTwo 11-14

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided. ONLY for models with factory navigation. Dev

Fits:

Smart ForTwo Year(s):11-14




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Please read all of the instructions and look at the pictures before attaching the ClicOn.

ONLY for models with factory navigation. Device holder must not be wider than 7cm, or it will block the navigation screen when opening.

NOTE: For models with factory navigation.
1. Press the thin end of the enclosed gap opener into the gap between the padded part of the dashboard and the frame surrounding the stereo, to widen the gap. Open the glove compartment door. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn.  
 
2. Hook the angled edge on the left side of the ClicOn around the sidewall edge.  
 
3. Place your fingers on the left side of the ClicOn and push firmly to the right, towards the stereo, so the angled edge on the right side goes into the gap above the gap opener. Press firmly forward with you thumb to make sure the angled edge goes all the way into the gap. Pull out the gap opener. Close the glove compartment door.  
 
4. The ClicOn is in place.

Please read all of the instructions and look at the pictures before attaching the ClicOn.

ONLY for models with factory navigation. Device holder must not be wider than 7cm, or it will block the navigation screen when opening.

NOTE: For models with factory navigation.
1. Press the thin end of the enclosed gap opener into the gap between the padded part of the dashboard and the frame surrounding the stereo, to widen the gap. Open the glove compartment door. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn.  
 
2. Hook the angled edge on the left side of the ClicOn around the sidewall edge.  
 
3. Place your fingers on the left side of the ClicOn and push firmly to the right, towards the stereo, so the angled edge on the right side goes into the gap above the gap opener. Press firmly forward with you thumb to make sure the angled edge goes all the way into the gap. Pull out the gap opener. Close the glove compartment door.  
 
4. The ClicOn is in place.

Contains 1 x vehicle specific dash mount