ClicOn No Holes Dash Mount for Mitsubishi Fuso Canter 10-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 654789
 

ClicOn Angled Mount for Mitsubishi Fuso Canter 10-14

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Fuso Canter 10-19
Mitsubishi Fuso Canter 10-17




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Attention! Read all instructions before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap opener into the gap between the two dashboard sections, to widen the gap. Peel off the cover of adhesive tape on the ClicOn.

2. Press the angled edge on the upper part of the ClicOn into the gap next to the gap opener. Pull out the gap opener.

3. Press firmly on the lower part of the ClicOn so it flexes downward and hooks around the edge of the panel section.

4. The ClicOn is in place.

Attention! Read all instructions before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap opener into the gap between the two dashboard sections, to widen the gap. Peel off the cover of adhesive tape on the ClicOn.

2. Press the angled edge on the upper part of the ClicOn into the gap next to the gap opener. Pull out the gap opener.

3. Press firmly on the lower part of the ClicOn so it flexes downward and hooks around the edge of the panel section.

4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount