ClicOn No Holes Dash Mount for Toyota Prius C 12-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 654784
 

ClicOn Centre Mount for Toyota Prius C 12-14

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Toyota Prius c 12-17




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles
Please read all of the instructions and look at the pictures before attaching the ClicOn .

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of one of the enclosed gap openers into the gap between the air vent panel frame and the console ledge, to widen the gap. Peel off the cover of adhesive tape on the ClicOn. Press the angled edge on the lower part of the ClicOn into the gap next to the gap opener. Flip the ClicOn upwards and forward towards the center area of the dashboard so the angled edge on the lower part of the ClicOn hooks behind the edge of the trim. Pull out the gap opener.

2. On each side of the ClicOn, press the gap openers into the gap between the air vent panel frame and the dashboard. Start with the gap opener to the right of the ClicOn. Push on the upper part of the ClicOn so it flexes forward and hooks around the panel edge between the gap openers. Pull out the gap openers.

3. Attach the face plate to the ClicOn with the enclosed screws.

4. The ProClip is in place. This ClicOn can be attached also over the left air vent.

Please read all of the instructions and look at the pictures before attaching the ClicOn .

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of one of the enclosed gap openers into the gap between the air vent panel frame and the console ledge, to widen the gap. Peel off the cover of adhesive tape on the ClicOn. Press the angled edge on the lower part of the ClicOn into the gap next to the gap opener. Flip the ClicOn upwards and forward towards the center area of the dashboard so the angled edge on the lower part of the ClicOn hooks behind the edge of the trim. Pull out the gap opener.

2. On each side of the ClicOn, press the gap openers into the gap between the air vent panel frame and the dashboard. Start with the gap opener to the right of the ClicOn. Push on the upper part of the ClicOn so it flexes forward and hooks around the panel edge between the gap openers. Pull out the gap openers.

3. Attach the face plate to the ClicOn with the enclosed screws.

4. The ProClip is in place. This ClicOn can be attached also over the left air vent.

Contains 1 x vehicle specific dash mount