ClicOn No Holes Dash Mount for Chrysler Voyager 12-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 654650
 

ClicOn Angled Mount for Chrysler Voyager 12-14 Not the product you are looking for? Go to http://www.strike.com.au/products/dashmounts to start again




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles
Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Press the thin end of the enclosed gap opener into the gap between the climate control and the surrounding panel frame, to widen the gap. Use the enclosed alcohol pad to clean the area where the
ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn. Press the tip of the curved edge on the lower part of the ClicOn into the gap next to the gap opener.

2. Flip the
ClicOn upward, towards the air vent, and at the same time, press forward on the lower part of the ClicOn so the curved edge goes all the way into the gap.

3. Place your index fingers underneath the upper part of the
ClicOn. Pull so it flexes upward and then hook the angled edge over the lower air vent edge. Press firmly down on top of the ClicOn for best possible attachment of the adhesive tape. Pull out the gap opener.

4. The
ClicOn is in place.
Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Press the thin end of the enclosed gap opener into the gap between the climate control and the surrounding panel frame, to widen the gap. Use the enclosed alcohol pad to clean the area where the
ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn. Press the tip of the curved edge on the lower part of the ClicOn into the gap next to the gap opener.

2. Flip the
ClicOn upward, towards the air vent, and at the same time, press forward on the lower part of the ClicOn so the curved edge goes all the way into the gap.

3. Place your index fingers underneath the upper part of the
ClicOn. Pull so it flexes upward and then hook the angled edge over the lower air vent edge. Press firmly down on top of the ClicOn for best possible attachment of the adhesive tape. Pull out the gap opener.

4. The
ClicOn is in place.
Contains 1 x vehicle specific dash mount