ClicOn No Holes Dash Mount for Kia Optima 11-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 654641
 

ClicOn Centre Mount for Kia Optima 11-14 Not the product you are looking for? Go to http://www.strike.com.au/products/dashmounts to start again




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Attention! Read all instructions before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn. Hook the curved edge on the lower part of the ClicOn around the upper air vent edge.

2. Hold the enclosed gap opener in an angled position and press the thin end into the seam/gap on top of the dashboard, to widen the gap. Hold the gap opener in this position and then push forward on the upper part of the ClicOn so the angled edge goes into the gap next to the gap opener. Press down on top of the ClicOn to make sure the angled edge is all the way into the gap. Pull out the gap opener.

3 and 4. The ClicOn is in place.

Attention! Read all instructions before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn. Hook the curved edge on the lower part of the ClicOn around the upper air vent edge.

2. Hold the enclosed gap opener in an angled position and press the thin end into the seam/gap on top of the dashboard, to widen the gap. Hold the gap opener in this position and then push forward on the upper part of the ClicOn so the angled edge goes into the gap next to the gap opener. Press down on top of the ClicOn to make sure the angled edge is all the way into the gap. Pull out the gap opener.

3 and 4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount