ClicOn No Holes Dash Mount for Toyota Prius 10-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 654355
 

ClicOn Angled Mount for Toyota Prius 10-14 Not the product you are looking for? Go to http://www.strike.com.au/products/dashmounts to start again




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles
Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Open the cup holder lid. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap opener into the gap between the console edge and the console sidewall, to widen gap. Peel off the cover of adhesive tape on the ClicOn . Press the angled edge on the left side of the ClicOn into the gap next to the gap opener. Pull out the gap opener.

2. Place your hand on the left side of the ClicOn and push it firmly towards the cup holder. The ClicOn will now flex towards the cup holder and hook around the cup holder edge.

3. Press firmly down on top of the right side of the ClicOn to make sure the angled edge is appropriately attached over the cup holder edge and for best possible attachment of the adhesive tape. Close the cup holder lid.

4. The ClicOn is in place.
Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Open the cup holder lid. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap opener into the gap between the console edge and the console sidewall, to widen gap. Peel off the cover of adhesive tape on the ClicOn . Press the angled edge on the left side of the ClicOn into the gap next to the gap opener. Pull out the gap opener.

2. Place your hand on the left side of the ClicOn and push it firmly towards the cup holder. The ClicOn will now flex towards the cup holder and hook around the cup holder edge.

3. Press firmly down on top of the right side of the ClicOn to make sure the angled edge is appropriately attached over the cup holder edge and for best possible attachment of the adhesive tape. Close the cup holder lid.

4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount