ClicOn No Holes Dash Mount for Toyota Prius 10-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 654354
 

ClicOn Centre Mount [not for models with factory nav] for Toyota Prius 10-14

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Toyota Prius 10-16




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles
Please read all of the instructions and look at the pictures before attaching the ClicOn. This ClicOn fits over either air vent, you can also have two ClicOn attached next to each other. This installation instruction applies for both placements.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the angled edge of the enclosed gap opener upward into the gap between the upper part of the air vent and the padded dashboard overhang, to widen the gap. Peel off the cover of adhesive tape on the ClicOn .

2. Press the angled edge on the upper part of the ClicOn into the gap next to the gap opener.

3. Press the ClicOn upward and forward so the angled lower edge hooks into seam/gap between the air vent and the surrounding frame. Pull out the gap opener.

4. The ClicOn is in place
Please read all of the instructions and look at the pictures before attaching the ClicOn. This ClicOn fits over either air vent, you can also have two ClicOn attached next to each other. This installation instruction applies for both placements.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the angled edge of the enclosed gap opener upward into the gap between the upper part of the air vent and the padded dashboard overhang, to widen the gap. Peel off the cover of adhesive tape on the ClicOn .

2. Press the angled edge on the upper part of the ClicOn into the gap next to the gap opener.

3. Press the ClicOn upward and forward so the angled lower edge hooks into seam/gap between the air vent and the surrounding frame. Pull out the gap opener.

4. The ClicOn is in place
Contains 1 x vehicle specific dash mount