ClicOn No Holes Dash Mount for Volvo XC60 09-10

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 654297
 

ClicOn Centre Mount - Not for Cars with Factory Sat Nav for Volvo XC60 09-10

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Volvo XC60 09-10




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles
Please read all of the instructions and look at the pictures before attaching the ClicOn. It is very important to place the ClicOn in the exact same position as shown in the pictures.

1. Remove the coin shelf above the air vents. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap opener into the gap between the center console and the surrounding frame, to widen the gap. Peel off the adhesive tape covers on the ClicOn .

2. Press/hook the angled edge on the upper part of the ClicOn into the gap next to the gap opener. Pull out the gap opener.

3. Make sure that the notch in the lower part of the ClicOn is aligned with the hole in the dashboard, adjust the position if needed. Press forward on the lower part of the ClicOn so the notch snaps into place in the hole in the dashboard.

4. The ClicOn is in place.
Please read all of the instructions and look at the pictures before attaching the ClicOn. It is very important to place the ClicOn in the exact same position as shown in the pictures.

1. Remove the coin shelf above the air vents. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap opener into the gap between the center console and the surrounding frame, to widen the gap. Peel off the adhesive tape covers on the ClicOn .

2. Press/hook the angled edge on the upper part of the ClicOn into the gap next to the gap opener. Pull out the gap opener.

3. Make sure that the notch in the lower part of the ClicOn is aligned with the hole in the dashboard, adjust the position if needed. Press forward on the lower part of the ClicOn so the notch snaps into place in the hole in the dashboard.

4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount