ClicOn No Holes Dash Mount for Citroen C3 II Pluriel 06-10

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 653751
 

ClicOn Angled Mount for Citroen C3 II Pluriel 06-10 Not the product you are looking for? Go to http://www.strike.com.au/products/dashmounts to start again




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Please read all of the instructions and look at the pictures before attaching the ClicOn.

This ClicOn consists of two parts.

Part 1. Attaching part (the smallest part)

Part 2. Mounting plate

  • 1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap openers into the gap between the dashboard and the frame surrounding the control panel, to widen the gap. Peel off the cover of the adhesive tape on Part 1. Press the angled edge on Part 1 into the gap between the gap openers.

  • 2. Press Part 1 lefttwards so the angled edge hooks behind the frame surrounding the control panel. Pull out the gap openers.

  • 3. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Peel off the cover of the adhesive tape on Part 2. Place Part 2 onto Part 1 so the adhesive tape is to the right and the holes match. Screw Part 2 onto Part 1 with the enclosed screws. Screw straight into Part 1, in the same angle as Part 1.

  • 4. The ClicOn is in place.

Please read all of the instructions and look at the pictures before attaching the ClicOn.

This ClicOn consists of two parts.

Part 1. Attaching part (the smallest part)

Part 2. Mounting plate

  • 1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap openers into the gap between the dashboard and the frame surrounding the control panel, to widen the gap. Peel off the cover of the adhesive tape on Part 1. Press the angled edge on Part 1 into the gap between the gap openers.

  • 2. Press Part 1 lefttwards so the angled edge hooks behind the frame surrounding the control panel. Pull out the gap openers.

  • 3. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Peel off the cover of the adhesive tape on Part 2. Place Part 2 onto Part 1 so the adhesive tape is to the right and the holes match. Screw Part 2 onto Part 1 with the enclosed screws. Screw straight into Part 1, in the same angle as Part 1.

  • 4. The ClicOn is in place.

Contains 1 x vehicle specific dash mount