ClicOn No Holes Dash Mount for BMW 3 Series E90 05-12

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 653737
 

ClicOn Centre Mount with Nav & wood grain for BMW 3 Series E90 05-12 Not the product you are looking for? Go to http://www.strike.com.au/products/dashmounts to start again




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Attention: For vehcle with navigation unit and wood grain dash.

Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap opener into the gap between the wood grain trim and the center console panel, to widen the gap. When you do this the wood grain trim will flex upwards a few millimeters, which is OK. Peel off the cover of adhesive tape on the ClicOn.

2. Press the grooved edge on the lower part of the ClicOn into the gap next to the gap opener. Pull out the gap opener.

3. Press the gap opener into the gap between the wood grain trim and the dashboard ledge. Press forward on the top part of the gap opener, to widen the gap even more. At the same time: press forward on the upper part of the ClicOn, and then down on the edge of the ClicOn, so the angled edge goes into the gap next to the gap opener. Pull out the gap opener.

4. The ClicOn is in place.

Attention: For vehcle with navigation unit and wood grain dash.

Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Press the thin end of the enclosed gap opener into the gap between the wood grain trim and the center console panel, to widen the gap. When you do this the wood grain trim will flex upwards a few millimeters, which is OK. Peel off the cover of adhesive tape on the ClicOn.

2. Press the grooved edge on the lower part of the ClicOn into the gap next to the gap opener. Pull out the gap opener.

3. Press the gap opener into the gap between the wood grain trim and the dashboard ledge. Press forward on the top part of the gap opener, to widen the gap even more. At the same time: press forward on the upper part of the ClicOn, and then down on the edge of the ClicOn, so the angled edge goes into the gap next to the gap opener. Pull out the gap opener.

4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount