ClicOn No Holes Dash Mount for Toyota Prado 03-09

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 653197
 

ClicOn Angled Mount for Toyota Prado 03-09 Not the product you are looking for? Go to http://www.strike.com.au/products/dashmounts to start again




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Attention! Please read all of the instructions and look at the pictures before attaching the ClicOn.

This ClicOn consists of two parts.
Part 1. Attaching part (the smallest part)
Part 2. ClicOn face plate

  • 1. Peel off the cover of the adhesive tape on Part 1. Press the angled edge on part 1 into the gap between the control panel frame and the dashboard.

  • 2. Press to the left on Part 1, away from the steering wheel, so the angled edge hooks behind/under the control panel and the adhesive tape attaches.

  • 3. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Remove the cover of the adhesive tape on Part 2. Place Part 2 onto Part 1 so the holes match. Screw Part 2 onto Part 1 with the enclosed screw. NOTE! Screw the screws straight into Part 1, in the same angle as Part 1, do not screw the screws into place basing the angle on Part 2.

  • 4. The ClicOn is in place.

Attention! Please read all of the instructions and look at the pictures before attaching the ClicOn.

This ClicOn consists of two parts.
Part 1. Attaching part (the smallest part)
Part 2. ClicOn face plate

  • 1. Peel off the cover of the adhesive tape on Part 1. Press the angled edge on part 1 into the gap between the control panel frame and the dashboard.

  • 2. Press to the left on Part 1, away from the steering wheel, so the angled edge hooks behind/under the control panel and the adhesive tape attaches.

  • 3. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Remove the cover of the adhesive tape on Part 2. Place Part 2 onto Part 1 so the holes match. Screw Part 2 onto Part 1 with the enclosed screw. NOTE! Screw the screws straight into Part 1, in the same angle as Part 1, do not screw the screws into place basing the angle on Part 2.

  • 4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount