ClicOn No Holes Dash Mount for Daihatsu Sirion Gtvi 02-05

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 653165
 

ClicOn Angled Mount for Daihatsu Sirion Gtvi 02-05 Not the product you are looking for? Go to http://www.strike.com.au/products/dashmounts to start again




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Attention! Read all instructions and look at the pcitures before attaching the ClicOn.

This ClicOn consists of two parts.
Part 1: Attaching part (the smallest part)
Part 2: ClicOn face plate.


  • 1. Press the thin ends of the enclosed gap openers into the gap between the control panel and the dashboard to widen the gap. Place the gap openers approx. 10 cm apart.

  • 2. Peel off the cover of the adhesive tape on Part 1. Press part 1 into the gap between the gap openers. Press leftwards on Part 1, away from the steering wheel, so the angled edge hooks behind the control panel and the adhesive attaches on the dashboard. Pull out the gap openers.

  • 3. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Peel off the cover of the adhesive tape on Part 2. Place Part 2 onto Part 1 so the holes match and the adhesive is to the right. Screw Part 2 onto Part 1 with the enclosed screws. NOTE: Screw straight into Part 1, in the same angle as Part 1.

  • 4. The ClicOn is in place.

Attention! Read all instructions and look at the pcitures before attaching the ClicOn.

This ClicOn consists of two parts.
Part 1: Attaching part (the smallest part)
Part 2: ClicOn face plate.


  • 1. Press the thin ends of the enclosed gap openers into the gap between the control panel and the dashboard to widen the gap. Place the gap openers approx. 10 cm apart.

  • 2. Peel off the cover of the adhesive tape on Part 1. Press part 1 into the gap between the gap openers. Press leftwards on Part 1, away from the steering wheel, so the angled edge hooks behind the control panel and the adhesive attaches on the dashboard. Pull out the gap openers.

  • 3. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Peel off the cover of the adhesive tape on Part 2. Place Part 2 onto Part 1 so the holes match and the adhesive is to the right. Screw Part 2 onto Part 1 with the enclosed screws. NOTE: Screw straight into Part 1, in the same angle as Part 1.

  • 4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount