ClicOn No Holes Dash Mount for Mazda 6 02-07

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 653082
 

ClicOn Angled Mount for Mazda 6 02-07

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Mazda 6 02-07




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Attention! Read all instructions before attaching the ClicOn.

This ClicOn consists of two parts.
Part 1. Attaching part (the smallest part)
Part 2. ClicOn face plate

  • 1. Press the thin ends of the enclosed gap openers into the gap between the control panel and the dashboard to widen the gap. Place the gap openers about 10 cm apart.

  • 2. Peel off the cover of the adhesive tape on Part 1. Press Part 1 into the gap, between the gap openers. Press Part 1 to the left, away from the steering wheel, so the angled edge hooks behing the control panel and the adhesive attaches to the dashboard. Pull out the gap openers.

  • 3. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Peel off the cover of the adhesive tape on Part 2. Place Part 2 over Part 1 so the adhesive tape is on the right and the holes match. Screw Part 2 onto Part 1 by using the enclosed screws. NOTE! Screw the screws straight into Part 1, in the same angle as Part 1.

  • 4. The ClicOn is in place.

Attention! Read all instructions before attaching the ClicOn.

This ClicOn consists of two parts.
Part 1. Attaching part (the smallest part)
Part 2. ClicOn face plate

  • 1. Press the thin ends of the enclosed gap openers into the gap between the control panel and the dashboard to widen the gap. Place the gap openers about 10 cm apart.

  • 2. Peel off the cover of the adhesive tape on Part 1. Press Part 1 into the gap, between the gap openers. Press Part 1 to the left, away from the steering wheel, so the angled edge hooks behing the control panel and the adhesive attaches to the dashboard. Pull out the gap openers.

  • 3. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Peel off the cover of the adhesive tape on Part 2. Place Part 2 over Part 1 so the adhesive tape is on the right and the holes match. Screw Part 2 onto Part 1 by using the enclosed screws. NOTE! Screw the screws straight into Part 1, in the same angle as Part 1.

  • 4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount