ClicOn No Holes Dash Mount for Holden Vectra C 02-10

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 653077
 

ClicOn Angled Mount for Holden Vectra C 02-10

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Holden Vectra C 02-10
Opel Signum 03-08
Opel Vectra C 02-10
Vauxhall Signum 03-10
Vauxhall Vectra C 02-10




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Attention! Read all instructions before attaching the ClicOn.


This ClicOn consists of two parts.

Part 1. Attaching part (the smallest part)
Part 2. ClicOn face plate

  • 1. Remove the cover plate in the control panel by using the enclosed gap opener.
  • 2. Hook Part 1 behind the fram surrounding the control panel. Press the cover plate back into place.
  • 3. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Peel off the cover of the adhesive tape on Part 2. Place Part 2 over Part 1 so the holes match and so the adhesive tape is to the right. Screw Part 2 onto Part 1 with the enclosed screws. Note! Screw the screws straight into Part 1, in the same angle as Part 1.
  • 4. The ClicOn is in place.

Attention! Read all instructions before attaching the ClicOn.


This ClicOn consists of two parts.

Part 1. Attaching part (the smallest part)
Part 2. ClicOn face plate

  • 1. Remove the cover plate in the control panel by using the enclosed gap opener.
  • 2. Hook Part 1 behind the fram surrounding the control panel. Press the cover plate back into place.
  • 3. Open up the predrilled holes in Part 2 with a screwdriver (Philips). Peel off the cover of the adhesive tape on Part 2. Place Part 2 over Part 1 so the holes match and so the adhesive tape is to the right. Screw Part 2 onto Part 1 with the enclosed screws. Note! Screw the screws straight into Part 1, in the same angle as Part 1.
  • 4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount