ClicOn No Holes Dash Mount for ProClip - Hyundai Coupé 02-09

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 653037
 

ClicOn Angled Mount for ProClip - Hyundai Coupé 02-09

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Hyundai Coupé 02-09




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Attention! Read all instructions before attaching the ClicOn.

This ClicOn consists of two parts.
Part 1. Attaching part (the smallest part)
Part 2. ClicOn face plate

  • 1. Press the thin end of the enclosed gap opener into the gap between the dashboard and the surrounding frame to widen the gap. Peel off the cover of the adhesive tape on Part 1. Press Part 1 into the gap above the gap opener. Press Part 1 away from the steering wheel, so the adhesive tape attaches and the angled edge hooks behind/under the control panel. Pull out the gap opener.

  • 2. Press the gap opener into the gap between the control panel and the surrounding frame. Open up the predrilled holes in Part 2 with a screwdriver (Philips).

  • 3. Press the lower corner of the right edge of Part 2 into the gap below the gap opener. Press hard on the upper corner of the right part of Part 2 so it goes into the gap. Pull out the gap opener. Place Part 2 over Part 1 so the holes match. Screw Part 2 onto Part 1 with the enclosed screws. Screw the screws straight into Part 1, in the same angle as Part 1.

  • 4. The ClicOn is in place.

Attention! Read all instructions before attaching the ClicOn.

This ClicOn consists of two parts.
Part 1. Attaching part (the smallest part)
Part 2. ClicOn face plate

  • 1. Press the thin end of the enclosed gap opener into the gap between the dashboard and the surrounding frame to widen the gap. Peel off the cover of the adhesive tape on Part 1. Press Part 1 into the gap above the gap opener. Press Part 1 away from the steering wheel, so the adhesive tape attaches and the angled edge hooks behind/under the control panel. Pull out the gap opener.

  • 2. Press the gap opener into the gap between the control panel and the surrounding frame. Open up the predrilled holes in Part 2 with a screwdriver (Philips).

  • 3. Press the lower corner of the right edge of Part 2 into the gap below the gap opener. Press hard on the upper corner of the right part of Part 2 so it goes into the gap. Pull out the gap opener. Place Part 2 over Part 1 so the holes match. Screw Part 2 onto Part 1 with the enclosed screws. Screw the screws straight into Part 1, in the same angle as Part 1.

  • 4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount