ClicOn No Holes Dash Mount for Toyota MR2 Spyder 00-06

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 652819
 

ClicOn Angled Mount for Toyota MR2 Spyder 00-06

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Toyota MR2 Spyder 00-05




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Attention! Read all instrcutions before attaching the ClicOn.

Part 1: The attaching part (the smallest part)
Part 2: The ClicOn faceplate

  • 1. Press the thin end of the enclosed gap openers into the gap between the climate control panel frame and the padded dashboard to widen the gap. Peel off the cover of the adhesive tape on Part 1.

  • 2. Press the angled thin end of Part 1 into the gap between the gap
    openers. Press it firmly/hard forward at the same time you bend it to the left.

  • 3. Press Part 1 all the way in until the adhesive attaches. Pull out the gap openers. Press a Phillips screwdriver firmly through the large holes in Part 2 to
    open them up. Peel off the cover of the adhesive tape. Place Part 2 onto Part 1 so the holes match and the adhesive tape is on the right. Screw the enclosed screws into the holes.

  • 4. The ClicOn in place.

Attention! Read all instrcutions before attaching the ClicOn.

Part 1: The attaching part (the smallest part)
Part 2: The ClicOn faceplate

  • 1. Press the thin end of the enclosed gap openers into the gap between the climate control panel frame and the padded dashboard to widen the gap. Peel off the cover of the adhesive tape on Part 1.

  • 2. Press the angled thin end of Part 1 into the gap between the gap
    openers. Press it firmly/hard forward at the same time you bend it to the left.

  • 3. Press Part 1 all the way in until the adhesive attaches. Pull out the gap openers. Press a Phillips screwdriver firmly through the large holes in Part 2 to
    open them up. Peel off the cover of the adhesive tape. Place Part 2 onto Part 1 so the holes match and the adhesive tape is on the right. Screw the enclosed screws into the holes.

  • 4. The ClicOn in place.
Contains 1 x vehicle specific dash mount