ClicOn No Holes Dash Mount for Land Rover Freelander 98-04

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 652627
 

ClicOn Centre Mount for Land Rover Freelander 98-04

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Land Rover Freelander 98-03




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Attention! Read all instructions before attaching the ClicOn.


  • 1. Press the thin end of the enclosed gap opener into the gap between the dashboard and the air vent frame to widen the gap. Clean the surface above and below the air vent with the enclosed alcohol pad.

  • 2. Peel off the cover of the adhesive tape on the ClicOn. Press the lower part of the ClicOn into the gap between the air vent frame and the console ledge. Press it all the way in until it stops.

  • 3. Press forward on the upper part of the ClicOn so the angled edge snaps over the air vent frame and into the gap next to the gap opener. To make sure the angled edge is all the way in, press down on top of the ClicOn. Pull out the gap opener.

  • 4.The ClicOn is in place.

Attention! Read all instructions before attaching the ClicOn.


  • 1. Press the thin end of the enclosed gap opener into the gap between the dashboard and the air vent frame to widen the gap. Clean the surface above and below the air vent with the enclosed alcohol pad.

  • 2. Peel off the cover of the adhesive tape on the ClicOn. Press the lower part of the ClicOn into the gap between the air vent frame and the console ledge. Press it all the way in until it stops.

  • 3. Press forward on the upper part of the ClicOn so the angled edge snaps over the air vent frame and into the gap next to the gap opener. To make sure the angled edge is all the way in, press down on top of the ClicOn. Pull out the gap opener.

  • 4.The ClicOn is in place.
Contains 1 x vehicle specific dash mount