ClicOn No Holes Dash Mount for Land Rover Range Rover 95-01

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 652105
 

ClicOn Centre Mount for Land Rover Range Rover 95-01

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Land Rover Range Rover 95-01




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Attention: Please read all of the instructions and look at the pictures before attaching the ClicOn.


  • 1. Press the thin end of the enclosed gap opener into the gap between the air vent panel frame and the padded dashboard to widen the gap. (Note: You can attach the ClicOn anywhere within the width of the air vent) Clean the wood grain ledge with the enclosed alcohol pad and peel off the cover of adhesive tape on the ClicOn.

  • 2. Press the grooved edge on the upper part of the ClicOn into the gap next to the gap opener. Press until you see or hear/feel it snap into place. (Make sure the adhesive tape on the lower part of the ClicOn does not attach to the wood grain ledge, yet.)

  • 3. Place the edge of the lower part of the ClicOn up against the padding below the air vent and then press down on the inside of the ClicOn towards the ledge so the adhesive tape attaches properly. Pull out the gap opener.

  • 4. The ClicOn is in place.

Attention: Please read all of the instructions and look at the pictures before attaching the ClicOn.


  • 1. Press the thin end of the enclosed gap opener into the gap between the air vent panel frame and the padded dashboard to widen the gap. (Note: You can attach the ClicOn anywhere within the width of the air vent) Clean the wood grain ledge with the enclosed alcohol pad and peel off the cover of adhesive tape on the ClicOn.

  • 2. Press the grooved edge on the upper part of the ClicOn into the gap next to the gap opener. Press until you see or hear/feel it snap into place. (Make sure the adhesive tape on the lower part of the ClicOn does not attach to the wood grain ledge, yet.)

  • 3. Place the edge of the lower part of the ClicOn up against the padding below the air vent and then press down on the inside of the ClicOn towards the ledge so the adhesive tape attaches properly. Pull out the gap opener.

  • 4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount