ClicOn No Holes Dash Mount for Honda CR-Z 11-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 634553
 

ClicOn Console Mount for Honda CR-Z 11-14

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Honda CR-Z 11-17




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Attention! Read all instructions before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be
installed. Press the thin end of the enclosed gap opener into the seam/gap between the console edge and the center panel, to widen the gap. Peel off the cover of adhesive tape on the ClicOn. Press/hook the angled edge on the lower part of the ClicOn around the console sidewall edge by the carpet.

2. Flip the ClicOn upwards, towards the center console. Place your fingers underneath the upper part of the ClicOn and pull so it flexes upwards. Hook the angled edge over the console edge and into the gap next to the gap opener. Pull out the gap opener.

3. Press down on top of the ClicOn to make sure the angled edge is all the way into the gap, and for best possible attachment of the adhesive tape.

4. The ClicOn is in place.

Attention! Read all instructions before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be
installed. Press the thin end of the enclosed gap opener into the seam/gap between the console edge and the center panel, to widen the gap. Peel off the cover of adhesive tape on the ClicOn. Press/hook the angled edge on the lower part of the ClicOn around the console sidewall edge by the carpet.

2. Flip the ClicOn upwards, towards the center console. Place your fingers underneath the upper part of the ClicOn and pull so it flexes upwards. Hook the angled edge over the console edge and into the gap next to the gap opener. Pull out the gap opener.

3. Press down on top of the ClicOn to make sure the angled edge is all the way into the gap, and for best possible attachment of the adhesive tape.

4. The ClicOn is in place.

Contains 1 x vehicle specific dash mount