ClicOn No Holes Dash Mount for Subaru Outback 10-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 634452
 

ClicOn Console Mount - Right for Subaru Outback 10-14

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Subaru Outback 10-14




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Please read all of the instructions and look at the pictures before attaching the ClicOn.

NOT FOR USE WITH HORIZONTAL DEVICES


1. Press the thin end of the enclosed gap opener into the gap between the console edge and the center panel surrounding the gear shift, to widen the gap. Slide the gap opener, while in the gap, towards you approx. 3 inches/ 8 cm. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the cover of adhesive tape on the ClicOn.

2. Press the angled edge on the left side of the ClicOn into the gap next to the gap opener. Pull out the gap opener.

3. Press the thick end of the gap opener up behind the console sidewall by the carpet to create some distance between the sidewall and the carpet. (See arrow in picture) Press down on the top right side of the ClicOn so the angled edge flexes down and hooks around the sidewall edge. Pull out the gap opener.

4. The ClicOn is in place.

Please read all of the instructions and look at the pictures before attaching the ClicOn.

NOT FOR USE WITH HORIZONTAL DEVICES


1. Press the thin end of the enclosed gap opener into the gap between the console edge and the center panel surrounding the gear shift, to widen the gap. Slide the gap opener, while in the gap, towards you approx. 3 inches/ 8 cm. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the cover of adhesive tape on the ClicOn.

2. Press the angled edge on the left side of the ClicOn into the gap next to the gap opener. Pull out the gap opener.

3. Press the thick end of the gap opener up behind the console sidewall by the carpet to create some distance between the sidewall and the carpet. (See arrow in picture) Press down on the top right side of the ClicOn so the angled edge flexes down and hooks around the sidewall edge. Pull out the gap opener.

4. The ClicOn is in place.

Contains 1 x vehicle specific dash mount