ClicOn No Holes Dash Mount for Subaru Forester 13-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 604905
 

ClicOn Right Hand Mount for Subaru Forester 13-14 Not the product you are looking for? Go to http://www.strike.com.au/products/dashmounts to start again




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Please read the instructions and look at the pictures before installing the ClicOn.

 

1. Press the thin end of the enclosed gap opener into the lower gap between the panel surrounding the air vent and the dashboard, to widen the gap. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn. Press the bent edge of the lower part of the ClicOn into the gap next to the gap opener.

 

2. Pull out the gap opener. Press the gap opener into the upper gap between the panel surrounding the air vent and the dashboard. Press the upper part of the ClicOn forward. Press the angled upper edge of the ClicOn into the gap next to the gap opener.

 

3. Press the upper part of the ClicOn downward so it goes all into the gap and the adhesive tape attaches properly. Pull out the gap opener.

 

4. The ClicOn is in place.

Please read the instructions and look at the pictures before installing the ClicOn.

 

1. Press the thin end of the enclosed gap opener into the lower gap between the panel surrounding the air vent and the dashboard, to widen the gap. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn. Press the bent edge of the lower part of the ClicOn into the gap next to the gap opener.

 

2. Pull out the gap opener. Press the gap opener into the upper gap between the panel surrounding the air vent and the dashboard. Press the upper part of the ClicOn forward. Press the angled upper edge of the ClicOn into the gap next to the gap opener.

 

3. Press the upper part of the ClicOn downward so it goes all into the gap and the adhesive tape attaches properly. Pull out the gap opener.

 

4. The ClicOn is in place.

Contains 1 x vehicle specific dash mount