ClicOn No Holes Dash Mount for Toyota RAV 4 13-18

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 604894
 

ClicOn Right Hand Mount for Toyota RAV 4 13-18

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Toyota RAV 4 13-18




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Please read all of the instructions and look at the pictures before attaching the ClicOn.

It is important to place the ClicOn in the exact same position as shown in the pictures.

 

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape covers on the ClicOn. Pull out the rubber sealent on the A-post slightly. Press the angled edge on the lower part of the ClicOn into the gap.  
 
2. Press the ClicOn upward/forward so the angled upper part goes around the A-post.  
 
3. Press the upper angled edge of the ClicOns o the edge hooks around the A-post.  
 
4. The ClicOn is in place.

Please read all of the instructions and look at the pictures before attaching the ClicOn.

It is important to place the ClicOn in the exact same position as shown in the pictures.

 

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape covers on the ClicOn. Pull out the rubber sealent on the A-post slightly. Press the angled edge on the lower part of the ClicOn into the gap.  
 
2. Press the ClicOn upward/forward so the angled upper part goes around the A-post.  
 
3. Press the upper angled edge of the ClicOns o the edge hooks around the A-post.  
 
4. The ClicOn is in place.

Contains 1 x vehicle specific dash mount