ClicOn No Holes Dash Mount for Nissan Pulsar 13-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 604832
 

ClicOn Right Hand Mount for Nissan Pulsar 13-14 Not the product you are looking for? Go to http://www.strike.com.au/products/dashmounts to start again




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Please read all of the instructions and look at the pictures before attaching the ClicOn.

 

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape covers on the ClicOn. Pull out the rubber sealent on the A-post slightly.  
 
2. Press the angled edge on the lower part of the ClicOn into the gap and hook it around the A-post.  
 
3. Press the ClicOn upward/forward so the angled upper edge hooks around the A-post by the windshield. Press down on top of the ClicOn so the angled edge hooks properly into place.  
 
4. The ClicOn is in place.

Please read all of the instructions and look at the pictures before attaching the ClicOn.

 

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape covers on the ClicOn. Pull out the rubber sealent on the A-post slightly.  
 
2. Press the angled edge on the lower part of the ClicOn into the gap and hook it around the A-post.  
 
3. Press the ClicOn upward/forward so the angled upper edge hooks around the A-post by the windshield. Press down on top of the ClicOn so the angled edge hooks properly into place.  
 
4. The ClicOn is in place.

Contains 1 x vehicle specific dash mount