ClicOn No Holes Dash Mount for Mitsubishi Outlander 13-17

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 604818
 

ClicOn Right Hand Mount for Mitsubishi Outlander 13-17

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Mitsubishi Outlander 13-19




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Please read all of the instructions and look at the pictures before attaching the ClicOn.

 

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn. Pull out the rubber sealent on the A-post slightly. Note the small part of the A-post, the ClicOn is to be installed directly below it. Place the upper edge of the lower part of the ClicOn by the arrow shown in the picture.  
 
2. Press the angled edge on the lower part of the ClicOn into the gap and hook it around the A-post.  
 
3. Press the ClicOn upward/forward and hook the angled upper edge around the A-post. Press down on top of the ProClip so the angled edge goes all the way into the gap.  
 
4. The ClicOn is in place.

Please read all of the instructions and look at the pictures before attaching the ClicOn.

 

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the adhesive tape cover on the ClicOn. Pull out the rubber sealent on the A-post slightly. Note the small part of the A-post, the ClicOn is to be installed directly below it. Place the upper edge of the lower part of the ClicOn by the arrow shown in the picture.  
 
2. Press the angled edge on the lower part of the ClicOn into the gap and hook it around the A-post.  
 
3. Press the ClicOn upward/forward and hook the angled upper edge around the A-post. Press down on top of the ProClip so the angled edge goes all the way into the gap.  
 
4. The ClicOn is in place.

Contains 1 x vehicle specific dash mount