ClicOn No Holes Dash Mount for Honda CR-V 12-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 604770
 

ClicOn Right Hand Mount for Honda CR-V 12-14

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Honda CR-V 12-16




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles
Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the
ClicOn is to be installed. Peel off the cover of adhesive tape on the ClicOn. Place the ClicOn over the air vent part of the dashboard so the thin end on the lower part of the ClicOn meets the seem between the two panel sections of the dashboard. Press down on the ClicOn so the thin end goes all the way into the seem/gap.

2. Press the thin end of the enclosed gap opener into the seem/gap between the dashboard and the air vent, to widen the gap. Pull the upper part of the
ClicOn so it flexes upward and hook the angled edge into the gap next to the gap opener.

3. Press firmly down on top of the
ClicOn to make sure the angled edge goes all the way into the gap. Pull out the gap opener.

4. The
ClicOn is in place.
Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the
ClicOn is to be installed. Peel off the cover of adhesive tape on the ClicOn. Place the ClicOn over the air vent part of the dashboard so the thin end on the lower part of the ClicOn meets the seem between the two panel sections of the dashboard. Press down on the ClicOn so the thin end goes all the way into the seem/gap.

2. Press the thin end of the enclosed gap opener into the seem/gap between the dashboard and the air vent, to widen the gap. Pull the upper part of the
ClicOn so it flexes upward and hook the angled edge into the gap next to the gap opener.

3. Press firmly down on top of the
ClicOn to make sure the angled edge goes all the way into the gap. Pull out the gap opener.

4. The
ClicOn is in place.
Contains 1 x vehicle specific dash mount