ClicOn No Holes Dash Mount for Nissan Tiida 12-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 604700
 

ClicOn Right Hand Mount for Nissan Tiida 12-14 Not the product you are looking for? Go to http://www.strike.com.au/products/dashmounts to start again




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the cover of adhesive tape on the ClicOn. Pull/flip the rubber sealant open on the A-Post. Note: Use the enclosed gap opener to flip the sealant open if it is tight. Insert the angled edge on the lower part of the ClicOn into the gap and hook it behind the A-post panel edge.

2. Press firmly upwards with your right hand on the bottom part of the ClicOn and toward the right on the side of the ClicOn with your other hand. Press until you see, hear or feel the angled edge on the upper part of the ClicOn hook around the A-post panel edge by the windshield.

3. Press down on top of the ClicOn to make sure the angled edge is all the way into the gap. Note: If the gap is tight between the windshield and the A-post panel, use the enclosed gap opener to widen the gap.

4. The ClicOn is in place.

Please read all of the instructions and look at the pictures before attaching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be installed. Peel off the cover of adhesive tape on the ClicOn. Pull/flip the rubber sealant open on the A-Post. Note: Use the enclosed gap opener to flip the sealant open if it is tight. Insert the angled edge on the lower part of the ClicOn into the gap and hook it behind the A-post panel edge.

2. Press firmly upwards with your right hand on the bottom part of the ClicOn and toward the right on the side of the ClicOn with your other hand. Press until you see, hear or feel the angled edge on the upper part of the ClicOn hook around the A-post panel edge by the windshield.

3. Press down on top of the ClicOn to make sure the angled edge is all the way into the gap. Note: If the gap is tight between the windshield and the A-post panel, use the enclosed gap opener to widen the gap.

4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount