ClicOn No Holes Dash Mount for Lexus GX Series 10-14

Out-of-Stock: Normal lead time: 2 weeks

$48.99 (Incl. GST) ACC-DM 604496
 

ClicOn Right Hand Mount for Lexus GX Series 10-14

This Dashmount has been custom designed to fit your vehicle's dashboard without damaging your interior. Designed for mounting ClicOn holders. ONE Part of a TWO Part Solution. Installation instructions provided.

Fits:

Lexus GX Series 10-20




This ClicOn Dash Mount allows the user to connect their cradle their dashboard without the needs for drilling holes. They are car specific. They can be used with the full range of Strike Alpha Car Cradles & Holders see http://www.strike.com.au/products/Strike-Alpha-Car-Cradles

Attention! Please read all of the instructions and look at the pictures before ataching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be
installed. Peel off the cover of adhesive tape on the ClicOn. Press the thin angled edge on the lower part of the ClicOn into the seam/gap between the air vent and the surrounding panel frame.

2. Press firmly down on top of the ClicOn so it flexes downward. Then hook it into the seam/gap between the air vent and the surrounding panel frame. Note: While the ClicOn is in the air vent, you may have to wiggle and pull a little to get the angled edge to go into the seam/gap.

3. Place your finger underneath the ClicOn and press upwards to make sure the angled edge is all the way into the gap.

4. The ClicOn is in place.

Attention! Please read all of the instructions and look at the pictures before ataching the ClicOn.

1. Use the enclosed alcohol pad to clean the area where the ClicOn is to be
installed. Peel off the cover of adhesive tape on the ClicOn. Press the thin angled edge on the lower part of the ClicOn into the seam/gap between the air vent and the surrounding panel frame.

2. Press firmly down on top of the ClicOn so it flexes downward. Then hook it into the seam/gap between the air vent and the surrounding panel frame. Note: While the ClicOn is in the air vent, you may have to wiggle and pull a little to get the angled edge to go into the seam/gap.

3. Place your finger underneath the ClicOn and press upwards to make sure the angled edge is all the way into the gap.

4. The ClicOn is in place.
Contains 1 x vehicle specific dash mount